Catia Beginner - Creating a boundary surface

[Sally Alzaim]

Hello everyone. I am just moving on from solid works and I was wondering if there was a way to create a boundary surface between 2 profiles like the green border shown in the attached photo. In SW you can just choose boundary surface and chose the 2 directions (including the small corner). How do I go about this on Catia??

thanks
Sally

 

[MrCATIA]

I'm not that familiar with a SW Boundary Surface, but I think it's similar to a CATIA Multi-Section Surface or a Sweep Surface

 

[msainato]

You may also try using a Fill but the fill command needs a closed boundary.