Sargon III
New member
I use SW 2012. Below you see broken-out sections of thread junctions.
https://i.imgur.com/HCfQ1UA.png
https://i.imgur.com/73R32uq.png
It is obvious that the two hatches are superimposed in the interference zone. The outer and inner thread lines are covered each other too.
I want to see the hatch pattern of the outer thread only, i. e., the outer thread to be dominant. What could I do?
https://i.imgur.com/HCfQ1UA.png
https://i.imgur.com/73R32uq.png
It is obvious that the two hatches are superimposed in the interference zone. The outer and inner thread lines are covered each other too.
I want to see the hatch pattern of the outer thread only, i. e., the outer thread to be dominant. What could I do?