Continue to Site

VX CAM Tip: How to choose among drill, bore and ream operations.

C

CADMiester

Guest
Drilling is always the first to choose from as long as it meets your tolerance requirements. If higher tolerance is required, consider reaming next for smaller holes (less than 1 inch in diameter). Reaming is considered over boring because it is easier and more economic to perform. Boring should be considered for relative large holes only.

From VX Tips & Techniques Doc.
CADMiester
 
You must log in or register to reply here.

3DCAD Articles from Engineering.com

Sponsor

Back
Top