Hi,
Running Solid Edge ST9 on Windows 10 64 bit.
Normally I have not had an issue with this but today when I opened up SE, and tried to edit parts it keeps opening up a Windows Installer dialogue stating that its "Preparing to Intsall" and then just hangs. The only way to get past is to go into task manager end end Solid Edge
.
I did purchase a different PDF editor recently becasue I found Adobe to be very glitchy on my system. However SE was working after that install.
Ive done a .NET Framework cleanup to no avail.
I can open assemblies and adjust things, I just can create or edit any parts.
Any Help would be appreciated
Running Solid Edge ST9 on Windows 10 64 bit.
Normally I have not had an issue with this but today when I opened up SE, and tried to edit parts it keeps opening up a Windows Installer dialogue stating that its "Preparing to Intsall" and then just hangs. The only way to get past is to go into task manager end end Solid Edge
.

I did purchase a different PDF editor recently becasue I found Adobe to be very glitchy on my system. However SE was working after that install.
Ive done a .NET Framework cleanup to no avail.
I can open assemblies and adjust things, I just can create or edit any parts.
Any Help would be appreciated